Secure the bottom cut first.
Front porch roof flashing.
Install j channel along.
How to repair roof flashing small holes or corroded spots in flashing can be easily repaired.
Cut the siding at these lines.
Like ledger flashing installing brick flashing is not difficult to do and will extend the life of your front porch or deck.
Years ago many homes in the northeast had front porches built directly over the basement foundation.
Flashing a patio roof ledger.
More project and tips.
To prevent wood rot it is important to install flashing over your ledger board properly.
Plug pinholes with roofing cement and patch holes up to about 3 4 inch in diameter with a patch from the same material as the flashing.
Mark the location of the ledger against the siding.
How to install porch roof flashing step 1.
Try to keep the nails as flush as possible to the edges.
Prepare the area where you will install the roof flashing.
First roughen the area around the hole with a wire brush or sandpaper and then clean it.
The only thing holding back the cold snowy weather and the rain was 1 inch thick tongue and groove pressure treated porch decking that was painted to seal it from the elements and keep the water out.
The flashing on the wall should be flush against it and the porch roof portion should be on top of the shingles.
Place the flashing between the joint of the house and the roof.
The corner cut should be facing upwards.
Watch this ledger flashing siding step 1.
It has been too co.
Lay the cut flashing down at the corner over a shingle that is already in place.
Water and ledgers don t mix and that is why most fail.
Nail the flashing securely in place using roofing nails.
Cracks in the shingles can also be the culprit especially if the shingles are underneath a tree branch.
If you already have faulty flashing installed you.
Extend it past the cutout on both sides.
Measure the length of the porch roof joint to determine how much flashing you will need.
Slide z flashing up under the siding and secure with nails.